Fujitsu Point 1600, Installation Manual

Page: 24 / 52

2-8 Assembling and Installing Connectivity Peripherals
Assembling the High-Usage Cradle 2
The following outlines the process of assembling the high-usage cradle:
• Attach the cradle module to the cradle base.
• Install the AC adapter in the cradle base.
Detailed procedures for assembling the cradle module, cradle base, and AC adapter are given in this
section. (Peripherals, such as the keyboard and mouse, are attached later when the cradle is installed at
the work site.)
The following hardware, supplied with connectivity peripheral components, is used in this assembly.
(Note that other hardware is supplied that is not used in this assembly.)
• Knob, spacer, nylon washer, star lock-washer, screw, and cover (included with cradle base)
• Cover label (included with cradle module)
• Two tube keys for use with the tubular lock (included with the locking version of the cradle module)
To attach the cradle module to the cradle base,
1. Insert the cradle module into the cradle base, as shown in Figure 2-7. Note that this may be a snug fit.
The cradle base is equipped with metal brackets, one at each end where the screws fasten the cradle
module. A felt pad is glued onto each bracket. Ensure that the felt pads remain in position (between
the cradle module and the bracket) as you insert the cradle module.
2. Line up the holes in the side of the cradle module with those in the cradle base.