Fujitsu Point 1600, Installation Manual

Page: 21 / 52

Assembling the Port Replicator 2-5
replicator on the desk stand in one of three orientations: one landscape-mode and two portrait-mode
positions.
Figure 2-4. Port Replicator (Back View)
To install the wire catch,
1. Determine which set of mounting holes is appropriate depending on how you intend to orient the
pen tablet on the desk stand. Figure 2-4 shows the wire catch installed in the landscape-mode
position. The mounting holes for both portrait-mode positions are also called out.
2. Insert one end of the wire catch into the round hole.
3. Insert the opposite end of the wire catch into the corresponding slotted hole. To do so, push the end
of the wire catch inward until it can be inserted into the hole.
Note: Ensure that the wire catch is not installed backwards. When installed correctly, the wire catch hooks over
the top of the desk stand.
Connectors 2
Figure 2-5 shows the location of connectors on the port replicator. Note that the ability of the pen tablet to
utilize these connectors is determined by BIOS settings. Ensure that the ports you intend to use are
enabled and properly configured in the BIOS.
Feet
Feet
Wire Catch
Attach wire catch
here for portrait
orientation (right
side up). Attach wire catch
here for portrait
orientation (left
side up).