Fujitsu Lifebook P7010, User Manual

Page: 80 / 124

72
L i f e B o o k P 7 0 0 0 N o t e b o o k – S e c t i o n S i x
Your LifeBook notebook
will not work on battery
alone.
(continued)
The batteries are improperly
installed. Verify that the batteries are properly connected by
re-installing them.
Your installed batteries are
faulty. Verify the condition of the batteries using the Status
Indicator panel and replace or remove any batteries
that are shorted. (See Status Indicator Panel on
page 12 for more information)
The batteries seem to
discharge too quickly. You are running an application
that uses a lot of power due to
frequent hard drive or DVD/
CD-RW drive access, or use of a
modem or LAN PC card. Use both the primary battery and an optional
second battery and/or use a power adapter for this
application when at all possible.
The power savings features may
be disabled. Check the power management and/or setup utility
settings in the Power Savings menu and adjust
according to your operating needs.
The brightness is turned all the
way up. Turn down the brightness adjustment. The higher
the brightness the more power your display uses.
The batteries are very old. Replace the batteries.
The batteries have been exposed
to high temperatures. Replace the batteries.
The batteries are too hot or too
cold. Restore the notebook to normal operating tempera-
ture. The Charging icon on the Status Indicator
panel will flash when the battery is outside its
operating range.
Shutdown and Startup Problems
The Suspend/Resume/
Power On button does not
work. The Suspend/Resume/Power On
button is disabled from the
Advanced submenu of the Power
menu of the setup utility. Enable the button from the setup utility.
You did not hold the button in
long enough. Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
There may be a conflict with the
application software. Close all applications and try the button again.
The system powers up,
and displays power on
information, but fails to
load the operating system. Boot sequence settings of the
setup utility are not compatible
with your configuration. Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu. (See BIOS Setup
Utility on page 25 for more information)
You have a secured system
requiring a password to load
your operating system. Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly. (See BIOS Setup Utility
on page 25 for more information)
Internal hard drive was not
detected. Use the BIOS setup utility to try to auto detect the
internal hard drive. If this does not work, contact
Fujitsu Service and Support at 1-800-FUJITSU.
Problem Possible Cause Possible Solutions
P7010.book Page 72 Tuesday, April 20, 2004 2:26 PM