Fujitsu DL7600, User Manual

Page: 136 / 285

USING SETUP MODE
5-42
User's Manual
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Items
Options Description
<TEAR-EN>
(continued) In some application programs, data
transfer may stop temporarily due to
internal processing. This setting can
avoid an undesired tear off feed by
waiting for up to six seconds each
time data transfer stops.
<CUTLOAD> Single sheet auto loading.
AUTO
Single sheet paper is automatically
loaded a certain time after you set the
paper.
BUTTON Single sheet paper can be loaded by
pressing the LOAD button.
The following <LOADTIM> item is printed when CUTLOAD:AUTO
is specified for the <CUTLOAD> item.
<LOADTIM> Auto load start time.
0.5, 1.0, 1.5,
2.0 2.5,
3.0SEC Auto loading starts when this amount
of time passes after you set single
sheet paper.
<DECODE> Command decode timing.
DIRECT The printer decodes certain
commands immediately after
receiving data.
Example:
ESC SUB I, ESC CR
P () ESC
Q # (IBM XL24E)
QUEUED The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.