Fujitsu DL7600, User Manual

Page: 148 / 285

USING SETUP MODE
5-54
User's Manual
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-TST
HEX-DUMP V-ALMNT INITIAL
2. Select the DEFAULT function (LED type).
Repeatedly press the “TEAR OFF” or “LOAD” button to
position the cursor on the left edge of the aluminum print guide
on DEFAULT. Press the button or the button to select the
DEFAULT function. The printer reprints the <<FUNCTION>>
menu. The default values in MENU1 and MENU2 are now reset
(not saved yet).
3. Save reset values (LED type).
To exit setup mode and save the new defaults, make sure that
the cursor on the left edge of the aluminum print guide are
positioned on SAVE & END, then press the MICRO button
or the MICRO button.
Procedure (for LCD type)
To reset the factory defaults in MENU1 and MENU2, select DEFAULT
in SETUP mode. Detail of method as follows:
1. Enter setup mode (LCD type).
Press the SETUP button at offline state. Check that the “
SETUP
MODE
” is displayed on LCD panel.
2. Select the DEFAULT function (LCD type).
Repeatedly press the “ ” or “ ” button to display “ SUB
FUNCTION
”. And then press the“ ” button to move lower layer.
And then repeatedly press the “ ” or “ ” button to display
“
DEFAULT ”. And then press the “SELECT” button to reset the
default values in MENU1 and MENU2 (not saved yet).
3. Save reset values (LCD type).
Exit setup mode, saving the factory defaults.
Push SAVE/EXIT button. Check that “
:SAVE :CANCEL ” is
displayed on LCD panel. Then press the“ ” button.