62S_Rev3
89
Error Message List
Error
Message
Reason
Solution
L-Too Long
Fiber
･
The cleave length (bare
fiber part) is too long.
･
Dust or dirt is on the
objective lens.
･
Confirm the setting position of the stripped fiber
end on the fiber cleaver. Check the cleave
length.
･
Execute the [Dust Check]. Clean the lens when
dust or dirt exists.
R-Too Long
Fiber
LR-Too Long
Fiber
X-Dark
Back Ground
･
Dust or dirt is on the
objective lens.
･
The LED or Camera
might be damaged.
・
Execute the [Dust Check]. Clean the lens when
dust or dirt exists.
･
Consult your distributor.
Y-Dark
Back Ground
L-Too Dusty
Fiber
•
Dust or dirt is on the fiber
surface.
•
Dust or dirt is on the
objective lens.
•
[Cleaning Arc] time is too
short or “OFF.”
•
Splicing indistinct core
fibers with the SM or DS
modes.
•
[Align] is set to “Core” to
splice indistinct core
fibers when using other
splice modes.
•
[Focus] is incorrectly set
when using other splice
modes.
•
Completely prepare the fiber again (strip, clean
and cleave).
•
Execute the [Dust Check]. Clean the lens if dust
or dirt exists.
•
Set the [Cleaning Arc] time to “150ms”. When
splicing carbon coated fibers, set to “200ms”.
•
Use the MM mode to splice indistinct core fibers
(i.e. MM fiber).
•
Set [Align] to “Clad” to splice indistinct core
fibers (i.e. MM fiber).
•
Set [Focus] to “Edge” to splice indistinct core
fibers (i.e. MM fiber). To splice distinct core
fibers, “Auto” or the correct focus value should
be entered.
R-Too Dusty
Fiber
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
