FujiFilm UA107x8.4BESM-T35K, Operating Manual

Page: 38 / 94

- 4 -
⑯ F.f Adjusting Knob
The flange focal length of the lens is adjusted by means of this knob.
⑰ F.f Locking Knob
This knob secures the F.f adjusting knob.
⑱ Bayonet Mount
The bayonet type mount used in installation onto a portable camera.
⑲ Pin
In installation of the lens, align this pin with the appropriate hole in the mounting surface of the camera or the lens
supporter.
⑳ Hook
In installation of the lens, hang this hook on that on the mounting surface of the camera or the lens supporter.
㉑ Pin
In installation of the lens onto a portable camera, align this pin with the hole in the mounting surface of the camera.
㉒ Spring Pin
In installation of the lens, this spring pin enters the appropriate hole in the mounting surface of the camera or the lens
supporter and prevent shaking of the lens.
㉓ Connector to Camera ( 57-10360, DDK )
The electrical connection with the camera is made through this connector.
㉔ Stabilizer H+V/OFF/V Select Switch
This switch selects ON / OFF of the optical image stabilization function and the correction direction.
With this switch set to
“
H+V,
”
the optical stabilizer functions responding to the vibration of both vertical and
horizontal directions, while set to
“
V,
”
it functions responding to the vibration of only vertical direction.
When this switch is set to
“
OFF,
”
the anti-vibration mechanism does not operate.
(When an optical stabilizer control unit is connected to this lens, the setting of the select switch on the optical
stabilizer control unit has priority to the setting of this switch.)
㉕ Tally Lights HIGH/LOW/OFF Select Switch
The intensity of illumination of the tally lights can be selected from High or Low intensity.
When the switch is set to OFF, the tally lights go out.
㉖ Connector for Focus, Zoom Control (PT02A-16-26S, BENDIX)
This connector is provided for a connection cable, one or two ends of which are connected to a focus control unit and
a zoom control unit.
㉗ Connector for Power Source (XLR-4-32-F152, ITT CANNON)
This connector is provided for a DC power source.
If the camera is not able to supply sufficient electric power to the lens,
use a DC power source.
Connctor ITT CANNON (XLR-4-32-F152)
Pin1 GND(0V)
Pin2 NC
Pin3 NC
Pin4 +12V(+12 ～ +16V), More than 3.5A
㉘ Stabilizer HIGH/STD. Select Switch
The stabilizing characteristic of the optical stabilizer can be selected by means of this switch. (When an optical sta-
bilizer control unit is connected to this lens, the setting of the select switch on the optical stabilizer control unit has
priority to the setting of this switch. If the optical stabilizer control unit connected to this lens is not equipped with a
select switch, the stabilizing characteristic cannot be changed.)
The suitability of stabilizing characteristic mode settings and
pan and tilt operation by the operator is shown in the table at
right.
㉙ Macro ON/OFF Select Switch
With this switch set to ON, the macro operation (taking a close-up shot) can be performed.
Mount a cap on the power connector
towards the horizontal.
MODE
Pan and Tilt Operation
Yes No
STD. ○ ◎
HIGH ◎ ○
◎＝
Optimal
〇＝
Suitable