FujiFilm UA107x8.4BESM-T35K, Operating Manual

Page: 31 / 94

- iii -
CAUTION
◆
Take care when carrying the lens. Dropping the lens while carrying may cause injury.
◆
Before supplying the power to the lens, make sure all the parts are connected correctly.
◆
In order to install or release the lens cable, be sure to hold the joint part. Do not damage the cable by gripping. It
may cause fire or electric shock.
◆
If any sorts of incidents such as unusual smoke, noise, smell or obstacles are found, shut off the power supplied to
the lens and pull out the lens cable immediately. Please notify the sales agent from which you purchased the lens.
◆
Do not remodel the product: it may impair the functions of product or cause electric shock.
NOTICE
◆
Lens and its accessories are extremely precise instrument, then be sure not to apply the strong impacts to them. If
the lens is of a type in which the rear lens protrudes from the flange surface of the lens mount, be sure not to apply
impact to the lens part when installing or releasing.
◆
There may be a case that the glasses of the lens mist when the lens is carried from a cool place to a place of high
temperature and high humidity. To avoid a mist on the glasses, before moving the lens, let the lens adjust to the
ambient temperature of the place where the lens will be used.
◆
Be sure not to apply impact to the front part of the lens when operating the camera.
◆
Put the cap on the lens while the camera is not used.
◆
If an accessory to be attached to the lens is equipped with a mechanical drive relaying part, before attaching it,
check the joint part and get rid of all obstacles. If there are any unusual conditions, please contact the sales agent
from which you purchase the product.
◆
When the lens is used in the weather of fog, raining, or snowing, cover up the lens to prevent it from the water.
◆
When this product is used or is attached or detached in an environment with an excess of dust or fine particles,
make sure to prevent dust or fine particles from entering into the product. If dust sticks to or gets inside the
product, it may cause a malfunction.
◆
When this product is used, stored, or put in standby state in a high- or low-temperature environment, provide heat
shielding or thermal insulation measures to prevent damage to this product and the entire camera system.
◆
To minimize the impact to the lens in transportation, set the zoom to the wide end and the focus to the infinity side
end before releasing the lens from the camera.
FOR YOUR SAFETY USE
MEMO