9
1
1. OPERATIONAL SAFETY AND USE CONDITIONS
film feed mode is switched automatically, the film feed direction is
indicated. Take care of the ejecting direction of film.
• When installing the IX240 cartridge, take care of the direction of the
cartridge.
• Reshaping the trailing end of the IX240 film is limited in length. Refer
to Subsection 4.30.2 of the “Operating Instructions”.
Precautions for handling the auto film carrier NC100AY:
z
When installing the carrier, keep the carrier horizontal. If the carrier is installed
with the front side raised, the carrier may be damaged.
x
When moving the carrier, hold the handles using both hands in a balanced
manner. Do not hold the part except by the handles.
c
Do not open the carrier cover forcibly beyond the limit of the stopper because
this may cause damage to the carrier.
v
Close the pressure cover after checking that there is no foreign matter in the
carrier. If there is any foreign matter in the carrier, the glass surfaces of the
sensors may be damaged.
b
Do not deliver any impact to the glass surfaces of the sensors because this may
damage the glass surfaces.
n
Be sure to clean the feed lanes and feed rollers of the carrier once a day. If any
dust or dirt remains, a film feed error, frame position misalignment or scratches
on film may result. (When rotating the feed roller cleaning knob swiftly, the
indicator lamp may light. But this is not a failure.)
• Be sure to clean the magnetic heads using a cotton swab
with the alcohol water during the post-operational check. If
the magnetic heads are dirty, a magnetic information reading
failure may result.
• Do not use a film cleaner or alcohol water when cleaning the
parts for the film feed lane parts or glass surfaces. This may
cause a film feed failure or image scanning failure.
• Do not use a cotton swab moistened with alcohol water for
cleaning the glass surfaces of the sensors. Otherwise the
alcohol water may penetrate into the rear side of the glass
surface and abnormal sensor output may result.
m
When the pressure cover is opened for cleaning or inspection, do not drop any
foreign matter on the feed lanes. If any foreign matter is dropped on the feed
lanes, the glass surfaces of the sensors or feed lanes may be damaged,
causing scratches on film.
,
Do not try to close the carrier cover while the IX240 winding section cover is
open. The carrier cover may be damaged due to the excessive force applied.
NOTE: • When installing the 135 insertion section upper guide into the holder,
face the projecting section downward.
• When scanning film after IX240 cartridge film feed failure occurs and
film is removed, install the carrier into the scanner and then pull the
cartridge set lever after the initialization of the carrier.
Precautions for handling film before scanning it using the auto film carrier
NC100AY:
z
In the following cases, mend the film or use the multi film carrier MFC10AY.
• When film has torn perforations
• When the leading end of film is excessively slanted or sharply pointed
• When film is bent or heavily curled
Otherwise a film feed error or damage to film may result.
IMPORTANT
SP3000_instruct_E.book 9 ページ ２００７年１２月１１日 火曜日 午後１時６分
