FujiFilm SonoSite Edge II, User Manual

Page: 13 / 264

En
glish
De
utsch
Español
Fr
a
n
ça
is
It
a
lia
n
o
Po
rt
u
g
u
ê
s
Clean and disinfect system and transducer to a high level (semi-critical uses) 11
English
De
ut
sch
Español
Fr
a
n
ç
a
is
Ita
lia
no
P
o
rtuguês
Nederlands
8 Verify that all gel, debris, and bodily fluids have been removed from the system and transducer. If
necessary, repeat steps 5, 6 & 7 with a new wipe.
9 Examine the system, transducer and cable for damage, such as cracks or splitting where fluid can enter.
If damage is evident, do not use. Instead, contact FUJIFILM SonoSite or your local representative.
10 Prepare the disinfectant for use.
a
Choose a high-level disinfectant from the list of approved disinfectants.
b
Check the expiration date on the bottle to ensure the disinfectant has not expired.
c
Mix or check that the disinfection chemicals have the concentration recommended by the manufacturer
(for example, a chemical strip test).
d
Check that the temperature of the disinfectant is within the manufacturer’s recommended limits.
11 Perform a high-level disinfection of the transducer. Use the following procedure:
a
Immerse the transducer in a high-level disinfectant solution.
WARNING Failure to remove all gel, debris, and bodily fluid could leave contaminants on the
probe.
High-level disinfectants compatible with SonoSite Edge II transducers
Disinfectant Compatible transducers Temperature Disinfectant Soak Duration
Cidex C8x, C11x, C35x, HFL38xi,
HFL50x, HSL25x, ICTx, L25x,
L38xi, P10x, P11x
1
, rC60xi,
rP19x
25°C, 77°F 45 minutes
Cidex OPA C8x, C11x, HFL38xi, HFL50x,
HSL25x, ICTx, L25x, L38xi,
L52x
2
, P10x, rC60xi, rP19x
20°C, 68°F 12 minutes
1
The P11x Transducer is not licensed for use in Canada.
2
The L52x Transducer is for veterinary use only.
Refer to the cleaners and disinfection document available at www.sonosite.com for a complete list of the most
current cleaners and disinfectants.
WARNING High-level disinfectants can cause harm to the patient if not completely removed
from the transducer. Follow the manufacturer’s rinse instructions to remove
chemical residue.