FujiFilm FinePix6900Zoom, Service Manual

Page: 27 / 143

FinePix6900ZOOM(U/E/EG) SERVICE GUIDE
3. Adjustment
27
<Fig.4-4> Menu screen <Fig.4-1> Program start screen
3-4-2.Using the Adjustment Program
Procedure
1) Once the initial settings of the adjustment software have been completed, end "FFW.exe" and start
"FFW.exe" once again.
2) Follow the instructions on the screen to set the camera to jig mode. <Fig.4-1>
3) Press the [Enter] key and follow the instructions to make each of the adjustments using the menu
screen. <Fig.4-2>
3-4.Adjustment
3-4-1.Procedures of the Camera Jig Mode
Procedure
1) Please set the mode dial to [SET UP] mode.
2) Please input 5V from DC-IN Jack.
3) Please connect the USB cable.
4) Please open the card cover.
(Please put special firmware (SSFDC) when you improve the version of the firmware.)
5) Please holding down the [SHIFT] button, them trun on the camera.
6) When a green lamp on the side of the mode dial lights, completely camera jig mode.
Important Notes
* When connected to a personal computer while in the camera jig mode, the camera is not
recognized as a removable disk.
* The camera's power switch does not work while in the camera jig mode. If a problem
occurs during adjustment, switch off the power by disconnecting the DC jack. To switch
on, reconnect the DC jack, then switch on the power to the camera.
* To quit the camera jig mode, use [End Settings] in the adjustment program.
Fx6900z.ff
FinePix6900zoom Adjustment PC soft
Procedures of the camera jig mode.
1) Please set the mode dial to [SET UP] mode.
2) Please input 5V from DC-IN Jack.
3) Please connect the USB cable.
4) Please open the card cover.
Please put special firmware (SSFDC)
when you improve the version of the firmware.
5) Please holding down the [SHIFT] button,
them trun on the camera.
6) When a green lamp on the side of the mode dial lights,
please press the [Enter] key!
Fx6900z.ff
Menu
[F1] Mode dial adjustment
[F2] Battery adjustment
[F3] CCD data input / OFD adjustment
[F4] CAM adjustment
[F5] AF adjustment
[F6] Flash adjustment
[F7] Firmware version check
[F8] End setting
X--> Quit