FujiFilm FinePix6900Zoom, Service Manual

Page: 25 / 143

FinePix6900ZOOM(U/E/EG) SERVICE GUIDE
3. Adjustment
25
3-3-8.Reading / Writing EEPROM Data
* This adjustment program can perform the same operations to read and write EEPROM adjustment data
as the adjustment remote controller (RM-95B). The procedures for doing this are described below.
Procedure
1) Start the adjustment program and enable communication between the personal computer and the
camera (FinePix6900zoom menu screen).
Note: For information on how to run the adjustment program, refer to the next page.
2) In the FinePix6900zoom adjustment program, from the menu bar, select [Data], then [EVR] <Fig.3-17>.
3) The [EVRdata] dialog box appears <Fig.3-18>.
4) The commands on the menu bar can be run.
(See below for descriptions of the menu-bar commands.)
Item Name Description
10/16 Decimal/hexadecimal conversion Decimal/hexadecimal conversion of displayed EVR data
Redraw screen Redisplays the EVR data
ROM ROM write Writes the specified EEPROM data
ROM ROM read Reads the specified EEPROM data
RAM RAM read Reads the specified RAM data
+1 +1 & RAM write Increments the specified RAM data
(data is not written to the EEPROM)
-1 -1 & RAM write Decrements the specified RAM data
(data is not written to the EEPROM)
FD mark Save/record* Saves the EEPROM's EVR data(page can be specified)
Writes saved EVR data to the EEPROM(page can be specified)
All RD (green) ROM data display Displays ROM data corresponding to address 80h
(up to 80h of data can be displayed at one time)
All RD (violet) RAM data display Displays RAM data corresponding to address 80h
(up to 80h of data can be displayed at one time)
PAGE Page Specifies a page (moves to specified page)
ADDR. Address Specifies an address (moves to the specified address)
*: EEPROM saving/recording can be performed by selecting the FD mark.
<Fig.3-17> EVR menu <Fig.3-18> EVR data
Menu
[F1] Mode dial adjustment
[F2] Battery adjustment
[F3] CCD data input / OFD adjustment
[F4] CAM adjustment
[F5] AF adjustment
[F6] Flash adjustment
[F7] Firmware version check
[F8] End setting
X--> Quit
Fx6900z.ff