FujiFilm FinePix S3Pro, Service Manual

Page: 50 / 102

50
4. Adjustments
FinePix S3Pro Service Manual
FinePix S3 Pro_W adjustment item selection screen
0. [ R ] : Flash memory reset
*Only use for when the MAIN PWB has been replaced.
1. [ F 4 ] : CCD Defect Correction
2. [ F 5 ] : Camera Adjustment
3. [ F 1 ] : Battery Voltage Adjustment
4. [ F 11 ] : VIDEO Adjustment
5. [ F 2 ] : REAR LCD PANEL Adjustment
6. [ F12 ] : End Setting
[ F 8 ] : Firmware Download
[Execute this item only when
need to change the firmware.]
[ X ] : Restart
Fx S3Pro ADJ Software Ver.1.00
<Fig. 4-7-5>
<Step 6>
<Note>
(1) ‘FxS3Pro W PC Soft Ver.1.00’ at the bottom-right of the screen indicates the version number of the adjustment software.
(2) After running firmware download, other adjustments may be required depending on the content of the download software.
In such cases, the items to be adjusted, and the sequence of adjustment, will be indicated separately.
(3) After starting the adjustment software and beginning communication with the camera, always run End Setting following
adjustment and before returning the camera to the customer. If the End Setting is not run, the PC will not recognize the
camera when the two are connected.
Reason: As the camera will remain in the Jig mode (repair mode), it will not be recognized with the normal camera drivers.
(4) When the adjustment is interrupted after the [X]:Restart key is pushed, it remains about the Jig mode.