FujiFilm FCR XG-1, Operation Manual

Page: 9 / 100

Introduction
1-3
1
2
3
A
B
C
Y
Z
010-021-20 09.2001
1.2 Operational Precautions
1.2.1 Laser Handling Precautions
CR-IR346RU Laser Unit Specifications
Class IIIb
Medium Semiconductor laser
Wavelength 660 nm
Maximum Output 50 mW (CW)
WARNING: The CR-IR346RU incorporates a Class IIIb laser with maximum output of 50mW.
To prevent exposure to its laser beams, observe the following precautions.
• Never open or remove the protective covers.
• Always contact a qualified service engineer immediately if you suspect there is a
malfunction.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
1.2.2 Preventing Electric Shock
WARNING: High voltage is supplied to the photomultiplier.
To prevent electric shock, please observe the following precaution.
• Never remove the protective covers from the unit.
WARNING: The power supply to the unit is AC 100-120 / 200-240 V. To prevent electric shock,
please observe the following precautions.
• Avoid installation sites where the equipment will be exposed to water.
• Always ground the equipment to a protective earth line.
• Make sure that all connections are secure and connected correctly.
1.2.3 Electromagnetic Compatibility (EMC)
The CR-IR346RU system complies with the standards for EMC that are applied in various
countries as follows.
• IEC60601-1-2: 1993 (Japan)
• FCC Rules Part 15, Class A (USA)
• EN60601-1-2 (Europe)
WARNING: Electromagnetic wave-sensitive parts, such as the FDD, HDD, photo-
multiplier, etc., are used in this equipment.
Do not place any objects that emit strong electromagnetic waves near
the equipment.