FujiFilm Apeos C3070, Reference Manual

Page: 39 / 58

39
2.7 Troubleshooting
Trouble during Printing
The color of the document
and of the copy differ. Execute [Calibration]. For details, refer to “[Image Quality]” of
Reference Guide - Operations .
Select an image quality type suitable for the document for [Original
Type].
Copy black text. If you feel the printout is too light, select [Text] for
[Original Type].
Part of the image is
missing on the copy. If the paper is damp, replace the paper.
Remove folded or wrinkled paper from the tray or replace the paper.
If the document is pasted or folded, the pasted or folded section may
not be laying flat on the document glass. Place a stack of white sheets
on top of the document to flatten the document against the document
glass.
The copy has a stripe
pattern. Stripes may be printed on the enlarged copies depending on the ratio.
Adjust the copy magnification ratio.
The image is not copied to
the desired size. Clean the document cover or document glass.
If the document is highly transparent, such as transparencies, place a
white sheet of paper on top of the document when scanning.
Load the document correctly.
The document is a non-standard size Enter the document size before
copying.
Symptom Cause/Remedy
The Note on status display
lamp is blinking. Check the error message displayed in the Control Panel and take
action to resolve the error.
Unable to print. Check whether the machine’s IP address is set correctly.
Check the data-reception control setting.
The print data size transmitted at one time may have exceeded the
upper limit of the receivable size of the machine. This can occur when
the receiving buffer size setting is configured to [Spool to Memory].
Divide the print data into the size smaller than the maximum
receivable size of the machine. If there are multiple pieces of print
data, reduce the number of files to print at one time before printing.
Symptom Cause/Remedy