Fuji Xerox DocuPrint P365 d, User Manual, Page: 120 / 217

120
Using the Operator Panel Menus
USB Settings
Use the
USB Settings
menu to change printer settings affecting a USB port.
NOTE:
•
Values marked by an asterisk (*) are the factory default menu settings.
• Port Status
NOTE:
•
Port Status feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on again.
Values:
• Adobe Protocol
Purpose:
To specify PostScript
®
communication protocol. You can configure the
Adobe Protocol
settings for the wired network.
The change becomes effective after the printer is turned off and then on again.
Values:
System Settings
Use
System Settings
to configure a variety of printer features.
NOTE:
•
Values marked by an asterisk (*) are the factory default menu settings.
• Power Saver Time
Purpose:
To specify the time for transition to Power Saver mode.
Values:
Select
1min
(default) for
Low Power Timer
if your printer shares an electrical circuit with your room lights and you
notice them flickering. Otherwise, select a high value to keep your printer available for frequent use with the minimum
warm-up time.
The printer automatically returns to the standby mode from the Power Saver mode when it receives data from the
computer. You can also change the status of the printer to the standby mode by pressing the
( Energy Saver ) button on
the operator panel.
Disable Disables the USB port.
Enable
*
Enables the USB port.
Auto Sets the PostScript
®
communications protocol automatically.
Standard Sets the PostScript
®
communications protocol to
Standard
.
BCP Sets the PostScript
®
communications protocol to
BCP
.
TBCP* Sets the PostScript
®
communications protocol to
TBCP
.
Binary Sets the PostScript
®
communications protocol to
Binary
.
Low Power
Timer 1min
*
Specifies the time taken by the printer to enter Low Power mode after it
finishes a job.
1–60 min
Sleep Timer 1min
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–60 min