15
4.1 Operation procedure
Set up the operational status by the following procedure.
Operation is started by using the keys on the front panel of the analyzer. Before use, please read
through the instruction manual for the analyzer.
4.
OPERATION
• When handling the standard gas such as calibration gas, read the instruction manual of the
standard gas carefully and use the gas correctly.
DANGER
• Avoid continuous operation with the casing drawn out.
• During operation, avoid opening the casing and touching the internal parts. Otherwise,
you may suffer a burn or shock hazard.
CAUTIONS
Mounting
Piping
Wiring
Check of piping
Purging inside alanyzer
Power switch on
Warming up
Alarm value setting
Hold setting
Remote range setting
Automatic calibration setting
Concentration setting of
zero (air) point and span
calibration gas
Zero/span calibration
Key lock ON/OFF setting
Intruduction of sample gas
(Start of measuring)
Refer to Item 3.1.
Refer to Item 3.2.
Refer to Item 3.4.
Refer to Item 4.2 (1).
Refer to Item 4.2 (2).
Refer to Item 4.2 (3).
Refer to Item 4.2 (4).
Refer to Item 5.2 3).
Refer to Item 5.2 4).
Refer to Item 5.2 5).
Refer to Item 5.2 6).
Refer to Item 5.2 1)
to 2).
Refer to Item 5.2 8)
to 9).
Refer to Item 5.2 7).
Refer to Item 4.3.
Carry out if needed.
Carry out if needed.
General Operation
Carry out if needed.
