700-G6-DB- Man Rev. 1 dft5 11 Feb 2021
Page 36/65
6.3.11
SET RANDOM TRANSMISSION BITRATE
Syntax:
RBR=bbbb
Access level: USER
Tx State:
Disabled
This command sets the random transmission bit rate where
bbbb
is the bit rate parameter and has
valid values of 100, 300 and 1200.
6.3.12
SET RANDOM TRANSMISSION INTERVAL
Syntax:
RIN=mm
Access level: USER
Tx State:
Disabled
Set the random transmission randomizing interval to mm minutes. The randomizing interval is the
interval in which a random transmission will occur if there is data in the random transmission
buffer. The actual transmission time will be random, but on average will occur at this rate. Valid
range is 5 to 99 minutes.
6.3.13
SET RANDOM TRANSMISSION RANDOMIZING PERCENTAGE
Syntax:
RPC=mm
Access level: USER
Tx State:
Disabled
This value determines the range of randomization as a percentage of the randomizing interval.
Random transmissions will occur at a uniformly distributed random time within this range and on
average occur at the randomizing interval rate. Valid range is 10 to 50%.
For example, for a randomizing interval =15 (minutes) and a randomizing percentage =20 (%), then
the time between any two random transmissions will be 12 to 18 minutes (15 ± 3 minutes).
6.3.14
SET RANDOM TRANSMISSION REPEAT COUNT
Syntax:
RRC=xx
Access level: USER
Tx State:
Disabled
The random transmission repeat count is the number of times a random transmission will be
repeated. The random transmissions will occur once every random transmission interval as
specified by the randomizing interval. The valid range of this parameter is 0 – 99. For example, a
value of 3 will direct the transmitter to send the data in the Random buffer 3 times before clearing it.
A value of 0 indicates that random transmissions will occur every random transmission interval until
the random buffer is cleared by the host.
