Example:
PFSD 0 A: Disable detection of 3-2 pulldown.
Command: PHSCAL
Description:
This command performs a Phase calibration. Refer to the appropriate section in the manual for the
procedure on how to setup the Compass S2 before using this command.
Parameters:
None.
Example:
PHSCAL: The system will perform a Phase calibration.
Command: RESET op
Description:
Resets the system to factory defaults.
Parameters:
op
- Reset operation: op[A|F] All|Factory
Example:
RESET A:
Resets system to factory defaults and deletes all user input
configuration
files.
RESET F:
Resets system to factory defaults but leaves any user input
configuration files intact.
Command: RTE n op
Description:
Switches the router preview input.
Parameters:
n
- Select source to route: n[1-9] where 9 = BLK
op
- Output to which the source is routed: op[M|P] Main | Preview
Example:
RTE 4 P: Switches the Preview to router input 4.
Command: SSTAT?
Description:
FACTORY USE ONLY
Example:
SSTAT A? : Returns a system status value.
Command: STAT?
Description:
FACTORY USE ONLY
Parameters:
None
Example:
STAT? : Returns a system status value.
Command: STATS?
Description:
Prints a System Status Log.
Parameters:
48
Compass
S
2
Summary of Contents for CN-2002
