FSR CN-2002, Operator'S Manual

Page: 57 / 69

None
Example:
STATS? : Status log will be printed to the screen of a terminal emulator.
Command: T nnn
Description:
T-Bar command for manual transitions. In order for this command to be activated, the system must
be put into Manual Transition mode. This is done by executing the TRN command (see below) with
a time of 9.0 seconds.
Parameters:
nnn - [0 – 255] where 0 = Scaler B, 255 = Scaler A
Example:
T 128 : Will display 50% of Scaler A and Scaler B on the Main Output display.
Command: TBLS n
Description:
Enable or Disable the backlighting on the front panel switches.
Parameters:
n - [0|1] Disable | Enable
Example:
TBLS 0 : This will turn off the backlights on the front panel switches.
Command: TCM n
Description:
This command sets the Remote Control mode for the Compass S2. Refer to the Terminal Remote
Control section of this document for further information.
Parameters:
n - [0|1] Folsom/Vista | FSR
Example:
TCM 0 : This will place the system into the Folsom/Vista remote control mode.
Command: TDI n
Description:
Sets the display to the specified intensity. Intensity values are 100, 75, 50, or 25 representing a
percentage of full intensity.
Parameters:
n - [25|50|75|100]
Example:
TDI 100 – Sets the display to full brightness.
Command: TDL
Description:
SYSTEM USE ONLY
Parameters:
None.
Command: TER nnn
Description:
Allows a remote control unit to emulate the function of the encoder knob on the front panel.
Parameters:
Compass
S
2
49