FS TAP Series, Reference Manual

Page: 233 / 340

TAP Series Switch Command Line Reference
233
Switch(config)# interface eth-0-1
Switch(config-if)# sflow flow-sampling rate 2048
% Warning: sFlow sampling requires high CPU usage, especially with a low rate.
Suggested rate not less than 32768.
This example shows how to disable sFlow counter sampling on interface eth-0-1
Switch(config)# interface eth-0-1
Switch(config-if)# no sflow flow-sampling rate
Related Commands
show sflow
15.7 sflow flow-sampling enable
Use this command to enable packet sampling on individual port.
Use the no form of this command to disable packet sampling.
Command Syntax
sflow flow-sampling enable ( input | output | both )
no sflow flow-sampling enable ( input | output | both )
input Sampling for input packets
output Sampling for output packets
both
Sampling for packets on both direction
Command Mode
Interface Configuration
Default
Disabled
Usage
Use this command to enable packet sampling on individual port. This command can only be
configured on a port which is not a link-agg group member. The port can be either a physical
port or a link-agg port.