FS TAP Series, Reference Manual

Page: 113 / 340

TAP Series Switch Command Line Reference
113
IP_ADDR IP address of the time server or peer
key NTP_KEYID Authentication key to use when sending
packets to this peer (1 to 64000)
version
NTP_VERSION Defines the Network Time Protocol (NTP)
version number
prefer Makes this peer the preferred peer that
provides synchronization
Command Mode
Global Configuration
Default
The server will not synchronize to this machine
Usage
Use this command to allow the software clock to be synchronized by a Network Time
Protocol (NTP) time server.
Use the no form of this command to delete the NTP server
Examples
The following example shows how to configure a switch to allow its software clock to be
synchronized with the clock by the device at IP address 172.16.22.44 using NTP version 2:
Switch(config)# ntp server mgmt-if 172.16.22.44 version 2
The following example shows how to restore default ntp server configure:
Switch(config)# no ntp server 172.16.22.44
Related Commands
show ntp status
10.9 ntp authentication
Use this command to enable NTP authentication, use the ntp authentication enable
command.