FS TAP Series, Reference Manual

Page: 154 / 340

TAP Series Switch Command Line Reference
154
Command Mode
Global Configuration
Default
No notifications controlled by this command are sent.
Usage
The snmp-server trap enable command is used in conjunction with the snmp-server trap
target-address command. Use the snmp-server trap target-address command to specify
which host or hosts receive SNMP notifications. To send notifications, you must configure at
least one snmp-server trap target-address command.
Examples
The following example shows how to set all traps enable:
Switch(config)# snmp-server trap enable all
The following example shows how to set all traps disable:
Switch(config)# no snmp-server trap enable all
Related Commands
snmp-server trap target-address
13.17
snmp-server trap target-address
To configure a remote trap management IP address, use the snmp-server target-address
command in global configuration mode.
Use the no form of this command to delete the target address.