3-6
3.4.3 Changing the JIB (Jug In
Box) oil reservoir
When the oil reservoir level is low and
displays TOP OFF OIL EMPTY, (see Figure
3). Press the check button to clear the
screen. Once the reservoir is refilled
and/or replaced, press and hold the or-
ange reset button next to the oil reservoir
(see Figure 8 on the following page) until
the message in the lower corner is no
longer displayed. If using solid shortening
see Appendix B for instructions.
1.
Open the cabinet and slide the JIB
from the cabinet (see Figure 4).
Figure 4
2.
Remove the cap and pour
any remaining oil in the con-
tainer into all fry vats equal-
ly (see Figure 5).
3.
Place new JIB upright and remove the
cap and foil seal (see Figure 6).
Figure 6
4.
Put the tube in the new full
container (see Figure 7).
5.
Slide the JIB onto the shelf
inside the fryer cabinet (as
seen in Figure 4).
6.
Press the JIB reset switch to
clear the Top Off Oil Empty
display on the FQ4000 control-
ler (see Figure 8).
WARNING
Do not add HOT or USED oil to a
JIB.
Figure 8
Figure 3
Top Off Oil Empty indicates that the oil reservoir is
empty.
Figure 5
Figure 7
