Appendix H:
Controlling the CMBT Bluetooth
Audio Receiver Remotely
38
The CMBT Bluetooth audio receiver has a physical button to initiate pairing and other useful functions. However, when
the CMBT is part of an ezRoom ceiling installation, that button is not easily accessible. Here’s how to control the CMBT
remotely from your CB6000 touch panel via the CNAP port of the CM3000, CM800Si, or ICR-01 Smart Receiver.
Defined Actions
The following actions are useful in controlling your CMBT Bluetooth Audio Receiver:
Control Action
Short name
Manual steps
Feedback
Start Bluetooth Pairing
Abort Pairing
Clear Pairing List
Cycle CMBT
BLUETOOTH AUDIO
RECEIVER Power
Short press
Double-press
Long press
Reboot
Single button press
lasting less than 2.4 sec.
Two short presses
with less than 0.5 sec
between them.
Single button press
lasting more than 3 sec.
(This must be done
while pairing is active to
avoid a reboot.)
A long press while
pairing is not active.
Hold until initial
feedback is heard.
Short, very low audio tones as
the CMBT BLUETOOTH AUDIO
RECEIVER enters Pairing mode,
and the LED will flash rapidly and
continuously throughout the 60
second period of active pairing.
Long, low audio tone as the CMBT
BLUETOOTH AUDIO RECEIVER
exits Pairing mode, and the LED
turns off.
Falling arpeggio audio tones,
LED remains flashing (still in
Pairing mode).
Four descending audio tones,
then power down. On release
of button, four ascending tones
as CMBT BLUETOOTH AUDIO
RECEIVER enters Connectable
state. LED is off.
The control actions can be invoked remotely using two commands: the “Short press” and the “Long press,” with other
actions available by combining these two commands, either manually or as part of an action sequence in the device.
Summary of Contents for CB6000
Page 1: ...CB6000 Installer Guide ...