104
Note!
Before fixing the FPA15 board (5) on the alignment pins, do the
following:
- TP 1500 RC / 1500 TIG: Apply a thin layer of lubricant to the seal of the remote-
control socket (7) (Fig.13)
- TP 1500 RC / 1500 TIG: Apply gentle pressure to the seal of the remote-control
socket (7), to prevent it being forced out when you press on the FPA15 board
(Fig.14)
- Snap the FPA15 board (5) (Fig.9) onto the rear alignment pin first
Fig.13
- Carefully insert the seal (7) for the
remote-control unit connection socket
into the front of the housing
(7)
- Swing the copper bracket (55) back
into its original position
- Carefully press the FPA15 board until
all the alignment pins have snapped
into place
- TP 1500 TIG:
Tighten the hexagon nut
(69) (width-across=13) for the screw-
fixing of the socket
- TP 1500 / 1500 RC:
In the socket,
tighten the M5x12 (TX20) screw (70)
with a torque of 2 Nm.
(7)
Fig.14
Fig.15
(55)
(69)
(70)
Fig.16
Fig.17
Fitting the seal
for the remote-
control unit
connection
socket
Fitting the FPA15
board
Summary of Contents for TP 1500
Page 1: ...1 Service Manual...
Page 53: ...53 Overall circuit diagram...
Page 54: ...54...
Page 114: ...114...
