Fronius Symo GEN24 3.0, Operating Instructions Manual, Page: 52 / 144

WARNING!
Danger due to damaged and/or contaminated terminals.
This can result in serious injury and damage to property.
▶
Before making any connections, check the terminals for damage and contamination.
▶
Remove contamination in the de-energized state.
▶
Have defective terminals repaired by an authorised specialist.
PV generator -
general informa-
tion 2 independent PV inputs (PV 1 and PV 2) are available. These can be connected to a
different number of modules.
When using for the first time, set up the PV generator according to the respective config-
uration (also possible later in the “System configuration” menu under the “Components”
menu item).
PV generator
configuration
3
‑ 5 kW
IMPORTANT!
The installation must be carried out in accordance with the nationally applicable stand-
ards and directives. If the arc detection integrated in the inverter is used for the require-
ment according to IEC 63027 for arc detection, the solar module strings must not be
combined in front of the inverter.
Total current (I
dcmax
) less than or equal to 12.5 A
PV generator settings:
PV 1: ON
PV 2: OFF
Combined solar module strings with total current
(I
dcmax
) greater than 12.5 A
PV generator settings:
PV 1: ON
PV 2: ON
PV 1 + PV 2 (connected in parallel): ON
IMPORTANT!
Splitting the total current (I
dcmax
) by
bridging from PV 1 to PV 2 at the terminal
is permitted up to ≤ 37.5 A.
52