41
EN-US
Energy Yield
The following settings can be changed/performed:
-
Meter deviation/calibration
-
Currency
-
Feed-in tariff
-
CO2 factor
Fan
to check the fan functionality
-
Select the desired fan using the ‘Up’ and ‘Down’ keys
-
Pressing the ‘Enter’ key starts the test for the selected fan.
-
The fan runs until the menu is exited by pressing the ‘Esc’ key.
Since contrast depends on temperature, it may be necessary to adjust the ‘Contrast’
menu item when environmental conditions change.
Illumination
Preset the inverter display illumination
The ‘Illumination’ menu item only applies to the inverter display background illumination.
Setting range
AUTO / ON / OFF
Factory setting
AUTO
AUTO:
The inverter display illumination is activated by pressing any key. If no key
is pressed for 2 minutes, the display backlight goes out.
ON:
The inverter display illumination is permanently on when the inverter is ac-
tive.
OFF:
The inverter display illumination is permanently off.
Setting range
Currency / Feed-in Tariff
Meter deviation/calibration
Meter calibration
Currency
Set the currency
Setting range
3-digit, A-Z
Feed-in tariff
Set the charge rate for the remuneration for energy fed into the grid
Setting range
2-digit, 3 decimal places
Factory setting
(depends on the country setup)
CO2 factor
Set the CO2 factor for the energy fed into the grid
Setting range
Test fan #1/test fan #2 (depending on the device)
