EMC device classification as per the rating plate or technical data.
EMC measures
In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g. when there is
sensitive equipment at the same location, or if the site where the device is installed is
close to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to
rectify the situation.
Data protection
The user is responsible for the safekeeping of any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.
Maintenance
Before switching on, always check the mains plug and cable as well as charger leads
and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-free clean-
ing agent only.
Maintenance and
repair
Maintenance and repair work must only be carried out by authorised personnel. Use only
original spare and wearing parts (also applies to standard parts). It is impossible to guar-
antee that bought-in parts are designed and manufactured to meet the demands made
on them, or that they satisfy safety requirements.
Modifications, installations or conversions are only permitted with the approval of the
manufacturer.
Obligations of the
operator
The operator must only allow persons to work with the device who:
-
are familiar with the fundamental instructions regarding safety at work and accident
prevention and have been instructed in how to use the device
-
have read and understood these operating instructions, especially the section
"safety rules", and have confirmed as much with their signatures
-
are trained to produce the required results.
Checks must be carried out at regular intervals to ensure that operators are working in a
safety-conscious manner.
Safety inspection
The manufacturer recommends that a safety inspection of the device is performed at
least once every 12 months.
The safety inspection may only be performed by an appropriately qualified electrician
-
After any changes have been made
-
After any additional parts are installed, or after any conversions
-
After repair, care and maintenance are carried out
-
At least every twelve months
For safety inspections, follow the appropriate national and international standards and
directives.
Further details on safety inspections can be obtained from your service centre. They will
provide you on request with any documents you may require.
8
