"Relays"
Under Relays, one of the following functionalities can be set for each of the 4 terminals,
viewed from left to right:
Aquamatic
-
Signal, e.g. for actuating a solenoid valve
-
"Standard" program with settings pre-configured at the factory
-
"User" program with user-defined setting options
-
For more information on Aquamatic, see the "Aquamatic" section of the "Options"
chapter.
"Charging"
“Charge 50%"
“Charge 80%"
"Charge Finish"
"Main Charge Finished"
-
Signal when main charging phase is finished
“Charge not complete”
-
Signal if the battery is prematurely disconnected from the charger
-
Can be set from 1 to 10 s
"Charge OK"
-
Battery is being charged or is already fully charged
“Cumulative Error”
-
Signal in the event of an error
-
A power failure can be displayed as an error ("ON" setting).
-
If the device is in an error state, a freely defined text can be displayed, which can
contain the contact details of the dealer, for example. Detailed information can be
found in the "USB mode" section.
Cumulative error + warning
-
In the same way as the "Cumulative error" function, the corresponding relay picks up
as soon as an error or warning is present.
"Signal Lamp"
-
It is possible to connect one or more suitable lamps to the relay board to indicate the
state of charge or the operating status of the battery charger.
-
Detailed information can be found in the "Signal lamp" section of the "Options"
chapter.
“Immobiliser”
ON
-
The relay picks up continuously as soon as the battery charger is connected to the
mains.
42
