Fronius MagicWave 2200 Comfort, Operating Instructions Manual

Page: 124 / 216

124
Cause: At minimum wire feed speed, the
motor current of the wire-feed unit
motor is outside the permitted
range. Possible reasons are dis-
engaged wire-feed unit motors or
wire feed problems.
Remedy: Engage the drive units of both wirefeeder motors, arrange the hosepack in
as straight a line as possible; check the inner liner for kinks or soiling; check
the contact pressure on the 2-roller or 4-roller drive of the push-pull unit.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause: At minimum wire feed speed, the
motor current of the push-pull unit
is outside the permitted range.
Possible reasons are disengaged
wire-feed unit motors or wire feed
problems.
Remedy: Engage the drive units of both wirefeeder motors, arrange the hosepack in
as straight a line as possible; check the inner liner for kinks or soiling; check
the contact pressure on the 2-roller or 4-roller drive of the push-pull unit.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.
Cause: At maximum wire feed speed, the
wire-feed motor does not deliver
any actual rotational speed value.
Remedy: Repeat the push-pull calibration.
If the error message re-appears:
Contact After-Sales Service.
Cause: At maximum wire feed speed, the
motor of the push-pull unit does
not deliver any actual rotational
speed value.
Remedy: Repeat the push-pull calibration.
If the error message re-appears:
Contact After-Sales Service,
faulty actual value pick-up St2 | E
14
Cause: At maximum wire feed speed, the motor current of the wire-feed unit motor
is outside the permitted range. Possible reasons are disengaged wire-feed
unit motors or wire feed problems.
Remedy: Engage the drive units of both wirefeeder motors, arrange the hosepack in
as straight a line as possible; check the inner liner for kinks or soiling; check
the contact pressure on the 2-roller or 4-roller drive of the push-pull unit.
Repeat the push-pull calibration. If the error message re-appears: Contact
After-Sales Service.