Fronius MagicWave 2200 Comfort, Operating Instructions Manual

Page: 62 / 216

62
Special functions and options
Arc break watch-
dog function If the arc breaks and the current does not start to flow again within the time specified in the
set-up menu, the power source cuts out automatically. The service code "no | Arc" appears
on the control panel.
To start the welding process again, press any key on the control panel or the torch trigger.
The settings for the arc break watchdog set-up parameter (Arc) are described in "TIG set-
up 2nd" section.
Ignition time-out
function The power source has an ignition time-out function.
Once the torch trigger is pressed, gas pre-flow begins immediately. Ignition then begins. If
an arc does not appear within the time specified in the set-up menu, the power source cuts
out automatically. The service code "no | IGn" appears on the control panel.
"E55" is displayed on the JobMaster TIG welding torch.
To try again, press any key on the control panel or press the torch trigger.
The settings for the ignition time-out parameter (ito) are described in the "TIG set-up 2nd"
section.