Servicing the system | 6
M0741021_en | Installation and operating instructions Spring blade agitator FBR
41
6.1 Maintenance work by the operator
r
Regular maintenance of the discharge extends the service life of the entire plant and
is a basic requirement for trouble-free operation!
2
3
10
3
1
9
8
5
4
6
7
W
M
Q
F
W
M
Q
F
W = weekly, M = monthly, Q = quarterly, F = prior to each fill of the fuel store
No.
Component
Int.
Operation
1
Motor / gears
W
r
Carry out a general visual inspection of the drive motor
Ä
No major oil leaks should be visible.
2
Gravity shaft / safety
switch
M
Function test of the safety switch:
r
Open the inspection cover of the gravity shaft
Ä
The system should switch off immediately.
r
Check the inlet area for material build-up and clean
where necessary.
r
Close gravity shaft cover
r
Check fault message on the controller
3
Sprinkler system
Sprinkler system ready for operation
r
Check the position of the sensor
r
Visual inspection of the sensor and the capillary tube
r
Check water supply for sufficient pressure
4
Flange bearing
F
r
Lubricate bearing at lubricating nipple with grease gun
5
Spring piles
r
Check that the connecting screws of the clamping plate
are firmly in position and tighten if necessary
Ä
Replace broken screws immediately
r
Check that the connections of the spring piles have a
little play (approx. 1mm)
Ä
Tighten or loosen the screws if necessary
r
Check spring piles for wear
Ä
Distance between the spring piles and cover plate
on the open trough must be at least 10 mm
6
Inlet area / transfer
channel
r
Check the inlet area for material build-up or jammed
fuel and clean if necessary
r
Check the shear plate in the entry area of the transfer
trough for wear
