Frigidaire LGUB2642LF2, Service Manual

Page: 132 / 187

Component Teardown
6-26
Fresh Food Compartment
Refrigerated Ice Maker
Finger Evaporator
Ice Maker Control Cover Removal
To service the ice maker control board, unplug unit
from wall outlet. Remove the two screws securing the
cover to the rear of the unit. (See Figure 6-76) With
the screws removed, the cover containing the board
can now be removed to gain access to the ice maker
electronic control.
Ice Maker Control Removal
To remove the ice maker control board, unplug unit
from wall outlet. Remove cover and disconnect the wire
harness from both ends of the control board. Then
carefully pull the board from the four retainers securing
the control board in position. (See Figure 6-76)
Ice Bucket Removal
To service the ice maker you will need to remove the Ice
bucket by pulling the ice bucket out of the ice maker
assembly.
Ice Bin Housing Removal
To remove the ice bin housing from the ice maker:
1. Remove the fresh food compartment shelves to aid
in access the ice maker components.
2. Remove three 1/4” mounting bolts that pass through
the housing and fasten into the frame of the
ice maker assembly. (See Figure 6-5877
3. Slide housing forward until the two shoulder screws
mounted to the right inner sidewall and lower left
inside edge drop out of locating slots cut in the
ice maker assembly and remove from unit.
Figure 6-77.
Figure 6-76.
Screws
Screw
Holes
Electrical
Connections
When handling and or replacing a control board it is
important the a technician have a wrist ground strap on
and connected to the cabinet or another grounding posi-
tion to prevent static electricity from damaging the board.