21
The temperature in the oven has been set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is too hot
or too cool, the temperature in the oven can be adjusted. Before adjusting, test
a recipe by using a temperature setting that is higher or lower than the
recommended temperature. The baking results should help you to decide how
much of an adjustment is needed.
To Adjust Oven Temperature:
1. Push the
BAKE button
.
2. Set the temperature to 550°F by pushing and holding the
UP
ARROW
button
.
3. Within 2 seconds, push and hold the
BAKE button
until the special 2 digit
display appears. Release the
BAKE button
. The display now indicates the
amount of degrees offset between the original factory temperature setting
and the current temperature setting. If the oven control has the original
factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F, in 5°F steps, by
pushing and holding the
UP
or
DOWN ARROW button
. Adjust until the
desired amount of offset appears in the display.
5. When you have made the desired adjustment, push the
CANCEL button
to
go back to the time of day display. When adjusting oven temperature, a minus
sign (-) will appear before the number to indicate that the oven will be cooler
by the displayed amount of degrees.
Changing Cooktop and
Oven Lights
Adjusting Oven
Temperature
Be sure the range is unplugged and all parts are COOL before
replacing the surface or oven lights. Wear a leather-faced glove for protection
against possible broken glass.
To Change the Cooktop Light
(some models)
1. Turn power off at the main source or unplug the range.
2. Remove Phillips Head® screws (2) that secure the light cover and then lift
the light cover off.
3. Remove bulb by rolling back and up. Install the new bulb by sliding down
and rolling forward into place.
4. Re-install light cover and secure with Phillips Head® screws (2).
To Change the Oven Light
(some models)
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock (if equipped) will then need to be reset. To reset, see
Setting the
Clock and Minute Timer
in this Owner's Guide.
Note: The adjustments made will not
change the self-cleaning temperature.
