20
General Cleaning
(continued)
To Remove and Replace Oven Door
To Remove Oven Door:
1.
Open the door to the fully opened position.
2.
Remove the screws (
A
) on each side of the oven door.
3.
Close the door about three-fourths of the way to the quarter-open position.
Grasp the door firmly on both sides and lift up and off the hinges.
4.
To clean oven door, see the cleaning chart on page 19.
To Replace Oven Door:
1.
Be sure the hinge arms are in the quarter-open position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2.
Hold the door at the sides near the top. Insert the hinge arms into slots at the
bottom of the door.
3.
Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4.
If the door is not in line with the oven frame, remove it and repeat the above
steps.
5.
Be sure to replace the screws on the oven door.
To Clean the Spice Rack (some models)
To mount the rack to the range refer to your Installation Instructions.
To Remove Spice Rack (some models):
1.
Remove all the spices from the spice rack.
2.
Lift up on the bottom of the spice rack to remove it from the support posts.
To Clean Spice Rack:
1.
Using a mild dish detergent, clean the spice rack. Cover stubborn spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Cleaners made
especially for stainless steel, chrome or copper are also recommended.
2.
Rinse with clean water and a cloth.
3.
Rinse off all cleaners and wipe dry before operating the range. Bluish stains
may result due to heat combining with the cleaning material; these stains
cannot be removed.
To Reinstall the Spice Rack:
1.
Place the spice rack on top of the support posts. Make sure the top lip hooks
over the top of the support posts and the side flanges are around the side of
the support posts as shown in the diagram in Figure 1.
To Remove and Replace Warmer Drawer
To Remove Warmer Drawer:
1.
Turn power off before removing the warmer drawer.
2.
Open the drawer to the fully opened position.
3.
Locate the latches on both sides of the warmer drawer. The left latch is visible.
However, the right side is not and is located inside the drawer glides.
4.
Pull up on the left glide latch while inserting a screwdriver over the right latch
and pushing down.
5.
Pull the drawer away from the range.
6.
To clean warmer drawer, see "Porcelain Enamel" in the cleaning chart on
page 19.
To Replace Warmer Drawer:
1.
Align the glide latches on both sides of the drawer with the slots on the drawer.
2.
Push the drawer back into the range.
The door is heavy. For safe,
temporary storage, lay the door flat with
the inside of the door facing down.
A
Figure 1
Electrical Shock Hazard
can occur and result in
serious injury or death.
Disconnect appliance from electric power
before cleaning and servicing the warmer
drawer.
