Frico sirefa, Original Instructions Manual, Page: 12 / 25

SIRe Advanced Fan Heater Water
32
GB
FF
FF
FF
Tue 10:45
00 :00
Tue 10:45
Main menu
System on/off
Fan control
Installer menu
Main menu>Installer menu
Enter password
(See manual)
0 0 0 0
>Installer menu
Installer status screen
Week program
>Installer menu
Installer status screen
Week program
>Installer menu>Week
program
Change program
New program step
Check program
>Installer menu>Week
program
Check program
Week program on/off
New program step
Check program
Tue Wed Thu Fri Sat Sun Mon
08:00
18:00
Check program
Tue Wed Thu Fri Sat Sun Mon
08:00
18:00
Day (1)
Night (2)
Day (1)
Night (2)
>Installer menu>Week
program
Remove program
Check program
Change program
>Installer menu>Week
program
Change program
Check program
Remove program
Remove program
Reset all
Remove single
Remove all
New program step 7/16
Mode
Day
Tue 10:45
Tue Wed Thu Fri Sat Sun Mon
Tue 10:45
Tue Wed Thu Fri Sat Sun Mon
End
Fan settings
Fan settings
2°C
002
FH4
Tue 10:45
00 :00
Tue 10:45
Change program
Tue 10:45
Tue Wed Thu Fri Sat Sun Mon
Tue 10:45
Tue Wed Thu Fri Sat Sun Mon
End
Tue Wed Thu Fri Sat Sun Mon
1. 08:00
2. 18:00
3. 10:00
4. 16:00 Night
Day
Night
Day
>Installer status screen
Functionality mode
Eco / Comfort mode
Program Adv.
Comfort
Installer menu
To enter the Installer menu, code 1932 is
entered. Select the digits using the rotary dial
and confirm using the forward arrow.
Installer status screen
Check the settings. The installer status screen
consists of three pages with settings, scroll
using the rotary dial.
Week program
Make settings for week program.
A basic program is pre-entered in SIRe.
Mon-Fri Day from 08:00, Night from 18:00
Sat Day from 10:00, Night from 16:00
Sun Day from 11:00:00, Night from 14:00
To check which program is set for a particular
day, select Check program and then switch
between the days using the rotary dial.
To check which days a certain program is
active, select a week day by pressing the
forward arrow, the program is marked and
those days that the program is used will be
underlined, switch between the programs for
a particular day using the rotary wheel.
To add program step, select New program
step. Confirm your selection with the forward
arrow. Select Day, Night or Off (if the unit
should not be in operation), set the time
for switch on and then for which days the
program applies, then go to End to finish.
A new program step does not replace a set
time for Day for example, but you can instead
select to change a program step.
To change a program step, select Change
program.
The program steps that should not apply
are removed in Remove program. One or all
program steps can be removed in the menu.
To return to the factory set basic program,
select Reset all.