1
Position of motion detector
If the vehicle is equipped with a motion detector,
the cargo compartment lighting is also activated
via the motion detector.
If the motion detector detects movement in the
cargo compartment while the vehicle is station‐
ary, the cargo compartment lighting will switch
on for approximately two minutes.
The cargo compartment lighting can be switched
on via the motion detector if:
R
The vehicle is stationary, the parking brake is
applied and you are not depressing the brake
pedal.
R
Vehicles with automatic transmission: the
selector lever is in position
j
and you are
not depressing the brake pedal.
R
The vehicle has not been locked from the out‐
side using the key.
If no change to the vehicle, such as a door open‐
ing, is detected over several hours, the motion
detector will automatically switch off. This pre‐
vents the battery from discharging.
Switching the interior lighting switch-off
delay time on/off
Multimedia system:
4
©
5
Settings
5
Light
5
Interior Lighting Delay
#
Switch the switch-off delay time on or off.
If the function is active, the interior lighting
will remain lit up for a short time when the
seat belt buckle is released.
Changing bulbs
Instructions for changing bulbs
&
WARNING Risk of burns from hot com‐
ponent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can
become very hot during operation.
When replacing a bulb, you could burn your‐
self on these component parts.
#
Allow the component parts to cool
down before replacing the bulbs.
When you are replacing the bulb, observe the fol‐
lowing:
R
Do not use any bulb that has been dropped or
has scratches on its glass surface. Otherwise,
the bulb may explode.
R
The bulb may explode if it is hot or if you
touch, drop or scratch it.
R
Stains on the glass surface reduce the
service life of the bulb. Do not touch the glass
surface with your bare hands. If necessary,
clean the glass surface with alcohol or spirits
in a cold state and wipe it down with a lint-
free cloth.
R
Protect bulbs from humidity and do not bring
them into contact with liquids.
Always ensure the bulbs are firmly secured.
If your vehicle is equipped with LED lamps, you
can check this as follows: the light cone will move
from top to bottom and back again when the
vehicle starts. For this to work, the low beam
needs to have been switched on before the vehi‐
cle is started.
Bulbs and lamps are a major part of vehicle
safety. Therefore, ensure that they are always
working. Have the headlamp setting checked reg‐
ularly.
R
Before changing the bulbs, switch off the
vehicle's lighting system. This will prevent a
short circuit.
R
Use bulbs only in closed lights that have been
designed for them.
R
Use only spare bulbs of the same type and
with the correct voltage.
If the new bulb also does not light up, consult a
qualified specialist workshop.
Light and vision 87
