Cyclone PRO User Manual
129
CYCLONE PRO
The target GND is connected to the Pin 2 of the target MON08 Header.
The target RESET line is directly connected to the Pin 4 of the target MON08
Header.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 10, acting as the communications line. The Cyclone PRO pulls up this
signal with a 10K Ohm resistor to the target VDD.
PORTA1, PORTA2 and PORTC1 are used for entering monitor mode. By
default the user may directly bring these signals out to the target MON08
Header, or ensure that they are pulled up/down according to the image.
13.21
68HC908KX
Figure 13-21: 68HC908KX Family MON08 Pinout
The target GND is connected to the Pin 2 of the target MON08 Header.
The user must pull up the RESET line to target VDD with an external resistor.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 8, acting as the communications line. The Cyclone PRO pulls up this
signal with a 10K Ohm resistor to the target VDD.
PORTA1, PORTB0 and PORTB1 are used for entering monitor mode. By
default the user may directly bring these signals out to the target MON08
Header.
Alternatively, the user may pull up PORTB0 and pull down PORTA1 and
