Freescale Semiconductor FlexRay MFR4310, Reference Manual

Page: 39 / 268

Device Overview
MFR4310 Reference Manual, Rev. 2
Freescale Semiconductor 39
2.4.3.2 A[9:7] — AMI/MPC Address Bus
A[9:7] are general purpose input pins. Their function is selected by the IF_SEL[1:0] pins. Refer to
Section 2.7, “External Host Interface ” for more information. The pins can be configured to enable or
disable pullup or pulldown resistors on the pins.
A[9:7] are AMI/MPC interface address signals.
2.4.3.3 OE#/ACS0 — AMI/MPC Read Output Enable, HCS12 Address Select Input
OE#/ACS0 is a general purpose input pin. Its function is selected by the IF_SEL[1:0] pins. Refer to
Section 2.7, “External Host Interface ” for more information. The pin can be configured to enable or
disable a pullup or pulldown resistor on the pin.
OE# is the AMI/MPC interface output enable signal. This signal controls MFR4310 data output and the
state of three-stated data pins D[15:0] during host read operations.
ACS0 is an HCS12 interface address select signal.
2.4.3.4 A[12:11]/ACS[2:1] — AMI/MPC Address Bus, HCS12 Expanded Address
Inputs
A[12:11]/ACS[2:1] are general purpose input pins. Their function is selected by the IF_SEL[1:0] pins.
Refer to
Section 2.7, “External Host Interface ” for more information. The pins can be configured to enable
or disable pullup or pulldown resistors on the pins.
A[12:11] are AMI/MPC interface address signals.
ACS[1:2] are HCS12 interface address select signals.
2.4.3.5 BSEL[1:0]#/DBG[0:1] — AMI/MPC Byte Select, Debug Strobe Points
BSEL[1:0]#/DBG[0:1] are general purpose input or output pins. Their function is selected by the
IF_SEL[1:0] pins. Refer to
Section 2.7, “External Host Interface ” for more information. The pins can be
configured to provide high or reduced output drive, and also to enable or disable pullup or pulldown
resistors on the pins.
BSEL[1:0]# are AMI/MPC byte select signals.
DBG[0:1] are debug strobe point output signals. The functions output on these pins are selected by the
debug port control register. Refer to
Section 3.4.16, “Strobe Signal Support ” for more information.
2.4.3.6 D[15:8]/PB[0:7] — AMI/MPC Data Bus, HCS12 Multiplexed Address/Data
Bus
D[15:8]/PB[0:7] are general purpose input or output pins. Their functions are selected by the IF_SEL[1:0]
pins. Refer to
Section 2.7, “External Host Interface ” for more information. These pins can be configured
to provide high or reduced output drive, and also to enable or disable pullup or pulldown resistors on the
pins.