7
1.
The Wheels (91) may be preattached. If they
are not, complete this step.
With the help of a second person, carefully raise
the Upright (96) and insert a Wheel (91) into the
bottom of each side of the Upright.
Be careful
not to pinch the 65" Wire Harness (not
shown) in the Upright.
Attach the Wheels (91) with two 3/8" x 2 1/2"
Bolts (34), two 3/8" Wheel Washers (57), and
two 3/8" Nuts (42) (only one of each is shown).
Do not overtighten the Nuts; the Wheels
must turn freely.
57
34
42
96
91
1
2. Place the Upright (96) near the front of the Base
Frame (75). Have a second person tip the
Upright back so that it rolls on the Wheels (91)
as shown. Insert the 80" Wire Harness (46) into
the round hole in the Upright.
96
75
46
2
91
3. Locate the 80" Wire Harness (46) and 65" Wire
Harness (48) in the Upright (96) access hole.
Connect the 80" Wire Harness (46) to the 65"
Wire Harness (48) at the front of the Upright
(96).
See the inset drawing. The connectors
should slide together easily and snap into
place.
If they do not, turn one connector and try
again.
IF THE CONNECTORS ARE NOT IN-
SERTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
Attach the Access Plate (9) to the Upright (96)
with two #8 x 1/2" Machine Screws (8).
8
46
96
48
9
3
48
46