Freefly movi pro, Operation Manual

Page: 104 / 110

104
| OPERATION MANUAL
TROUBLESHOOTING GUIDE
GIMBAL WON’T TURN ON
POSSIBLE CAUSE POSSIBLE SOLUTION
Batteries are discharged Replace discharged batteries with fully charged batteries
Batteries are damaged Replace all damaged batteries
Dispose of damaged batteries properly
GIMBAL ON BUT NO STABILIZATION ON ONE OR MORE AXIS
POSSIBLE CAUSE POSSIBLE SOLUTION
Axis Stiffness is set to 0 Use GCU Display or Mobile App to raise the
stiffness values on axes with (0) stiffness
A Motor Drive has been reset
due to voltage, temperature,
or current protection Restart the MōVI Pro
Dual Operator Radio Controller
is in Kill Mode Use the Mode Switch on the Radio Controller
to activate Dual Operator Mode
Gimbal is still initializing Make sure the gimbal is steady for 5 seconds
OSCILLATION ON ONE MORE GIMBAL AXIS
POSSIBLE CAUSE POSSIBLE SOLUTION
Stiffness setting is too high Reduce the Stiffness setting of the axis that is oscillating
using the Tuning menu on the GCU or MōVI Pro app
An Adjustment Clamp is not tightened Check all Adjustment Clamps for adequate tightness;
they must all be locked securely during operation
Camera mounting is not stiff enough The camera must be mounted rigidly to the Tilt Axis. Use
a wedge or spacer under the lens and/or on the sides of
the camera to increase mounting stiffness if necessary
Filter settings are incorrect
Note: The Gyro and Output filters
are advanced settings and should
only be modified if other methods of
reducing oscillation have failed If the oscillations are fast (buzzing), try
increasing the Filter settings under Expert Settings
on the GCU or MōVI Pro App. If they are slow
(rocking), try decreasing the Filter settings
HORIZON (ROLL AXIS) IS NOT LEVEL
POSSIBLE CAUSE POSSIBLE SOLUTION
Roll Trim not set Adjust the Roll Trim setting to achieve a level horizon