Freefly Alta 8 Pro, Manual

Page: 105 / 128

Users may land in Manual Mode, Altitude Mode, or letting the ALTA Pro land
autonomously when doing a waypoints mission. Quickly reverting to manual
mode when landing in Altitude mode will prevent ALTA Pro unwanted
movements .
Upon landing, disarm the motors by holding minimum throttle and full left yaw. This is
typically done on the left radio control stick by moving it to the bottom left corner with
mode 2 controllers. Disarming can only be done while in Manual Mode. Once the motors are
stopped and disarmed, the Orientations Lights will flash green, and the Status Light will
slowly flash white, indicating it is safe to approach ALTA Pro.
Only approach ALTA Pro after confirming that it is disarmed by verifying
the Status Light and Orientation Light colors.
The downwash from the propellers can disturb debris. This debris can be ingested by the
propellers or motors and cause damage. After the flight, ensure there is no damage to the
propeller blades and that the motors still spin freely and quietly. Take extra care when
operating in areas with large amounts of debris, such as in sand, dirt, or gravel.
After flight is also a good time to check the condition of battery packs. Always refer to the
battery manufacturer’s recommendations for inspection and replacement intervals or
requirements.
After Last Flight
Item Action
1. Propellers FOLD and PLACE inline with booms
2. Prop Protectors INSTALL
3. Boom Latches UNLOCK
4. Booms FOLD
5. Boom Retention Clips EXTEND