User Manual EML1101
Printer routines
9 Printer routines
Either a PC or a serial printer can be connected to
EML 1101
through a built-in RS232 interface.
The printer must be configured as follows (EPSON LX300):
−
Character interval
10cpi
−
Zero with/without oblique line
0
(not critical)
−
Ignore Page perforation
Off
(not critical)
−
Symbol table
PC437
−
Auto. line forward
Off
(not critical)
−
Page length
12 inch(
depending on paper)
−
Automatic separation
Off
(not critical)
−
Tractor
Individual
−
Interface
Auto. selection (10 sec.)
−
Baud rate
9600bps
−
Parity None
−
Word length
8 bit
−
ETX/ACK Off
Assigning the printer cable:
If a printer is connected to
EML 1101
, then the previous
day's power curve is printed out daily just after midnight
(see section 9.6).
If, during this time, a PC is connected
to the serial interface and the program OPT-SW is
active, the data will be sent to Windows standard printer.
If
EML 1101
cannot detect a printer or the printer is not
online, then the message "Printer off-line or no printer" is
displayed when menu item "Printer routines“
is selected
.
If a printer is connected the
menu items described in
are shown here.
9.1 Printing basic settings
All set values for the menu item
Basic settings
are given over the printer.
9.2 Printing load settings
The load settings for each profile are printed out on the printer one after the other. Due to the large
amount of data, there may be a long delay from the time
CR
button is pressed and the time printing
begins.
9.3 Power
failures
The last 10 power failures are
printed
.
9.4 Errors
After selecting this menu item, you can choose to print or delete the errors in another menu.
23
