frako EML 1101, Manual

Page: 20 / 50

Load settings PRELIMINARY User Manual EML1101
8 Load settings
Programming load settings can be done through the front fascia of EML 1101 or through OPT-SW
software (see section 3.3.3 Installation ) .
Program the load characteristics for every load channel used. Programming via the front fascia:
Select menu item Load settings with cursor buttons
and press CR button.
Load settings
Load settings
Profile 1
Select the profile for which the load settings are to be
changed with cursor buttons and press
CR button.
Load settings
Enter station and channel no.: EML / 1
The EML 1101 prompts for an entry of the station,
whereby station means EML 1101 or EMD 1101 Add-
on Station connected. Using cursor buttons, first
select the station. Then press CR button. Then select
the channel in the station. After the CR button is
pressed the channel name is shown and can only be changed with the OPT SW software . From this
menu item, use cursor buttons to proceed to other load settings. If an incorrect value is entered, press
MENU button to return to previous display and repeat the steps again.
Parameters to be set:
−
Power: Entry as four-figure number in kW
−
Define channel status
−
Minimum ON time: Up to 999:59 minutes:seconds
−
Maximum OFF time: Up to 999:59 minutes:seconds
−
Minimum OFF time: Up to 999:59 minutes:seconds
−
Output: Opener/closer
−
Define channel status: On/off/controlled
−
Priority: two-figure number
−
Group
8.1 Load name
This can only be changed using the configuration tool OPT-SW supplied. As factory settings, load
names are set as in the following example:
Channel 3 in EMD 2
Please note that when overwriting the entry with the
OPT-SW , a unique name must be assigned for
every consumer.
The name can have a maximum of 20 characters.
8.2 Priority
Priority Description
0 Always on in this profile
1 Most important channel
1-3 Channels that are only switched off in emergency mode.
It is not possible to set a min. ON time and a max OFF
time for priorities 1-3 under ‘POWER’ preference, as
they are only switched in emergency mode. The set time
are also observed in emergency mode under ‘TIME’
preference.
4-98 These priorities are switched in normal mode and in
emergency mode.
98 Least important channel
20