11
English
• MONITOR: to enable/deactivate the program bitrate monitoring if it has not been added to the
channel list. According to the program bitrate, it checks whether the program has been included in
the output mux or not.
• AVERAGE VALUE: shows the average program bitrate value.
• PEAK VALUE: to display the program peak bitrate value.
• PROGRAM PROP.: to display useful data about the programs.
• PROGRAM NAME: to display the program name,
• PROVIDER NAME: to display the provider name
• INPUT: to display the program input origin.
• PROGRAM TYPE: to display the program type (TV, RADIO,…).
• SERVICE ID: to display the program service ID.
• ADVANCED CONFIGURATION
• SELECT COUNTRY: to select the installation country.
• TSID: to display and change the ID associated to the transport stream by the broadcaster.
6 WEB INTERFACE
The 3DGFLEX can easily be programmed using the WEB interface, which can be accessed from the PC browser.
It is very important not to configure the 6 modules by using 6 different browsing boards at the same time, as
the CU does not respond to multiple parameter requests from the web, rather it takes the last window opened
as priority and the only one working.
IMPORTANT: in order to access web interface programming, the CU has to be outside the panel menu (logo
3DGflex Fracarro shown on the display).
NOTE: the WEB interface could be altered depending on the firmware release loaded in the module.
6.1 WEB INTERFACE CONNECTION
This is the procedure to access the web interface:
1. Connect the PC to the central unit using a RJ-45 CAT-5E cable or passing through a switch.
2. Change the PC or central unit IP address so they are compatible in the same subnet (so they can
communicate).
Example:
a. Parameters set in the properties of the PC Ethernet card:
IP: 192.168.0.3
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.0.1
b. Parameters to set in the control unit
IP: 192.168.0.2
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.0.1
3. Start the internet browser (recommended browsers: Google Chrome, Mozilla);
