14
Hampton® H15U-NG/LP Direct Vent Freestanding Gas Stove
installation
H15U
11.24.21
920-474
OPTIONAL FAN INSTALLATION
10)
Install the grommet in the hole at the back
of the unit and the clip wire holder. Slide
the thermodisc unto the bracket.
12)
Slide fan into place and secure with the
two screws removed in step 11.
Fan Kit (Part #384-917) contains:
Qty. Description
1 Fan Assembly
1 Thermodisc
1 Fan Speed Control
1 Grommet
1 Wire Holder
1)
Remove the rear access panel on the back of
the stove by removing the 2 screws under the
rear panel.
3)
Unbundle the wires to avoid straining it.
4)
Remove the Top Control Panel Assembly by
removing the three screws.
7)
Connect the red and black wires from the wire
harness to speed controller.
NOTE: Speed
control wires should be at the bottom of the
speed controller when the control panel is
in place.
5)
Remove the nylon hole plug from the control
panel.
6)
Install the fan speed controller onto the control
panel and secure with nut and washer.
2)
Lift rear panel off of 2 bolts at the top. Take care
not to cut wires when lowering the panel.
8)
Push black knob onto speed control.
9)
Re-attach control panel w ith screws r eversing
step 4.
11)
Remove 2 screws located at lower right
and left bottoms of the unit.
Nylon Plug
Thermodisc
Wire Holder
Grommet
Ground Lug for
‘‘Mobile use only’’
Optional Fan Installation
