20
FD-8
6. INSTALLING 2.5" INTERNAL HARD DISK DRIVE
The Model 9045 and a 2.5" E-IDE hard disk drive installing procedures are explained below.
• Bracket, HD, FD-4/8 (P/N: 8221234000) x 2
• Connector, PI, header, 50P, P2.0, A3E-50PA (P/N: 8245314000) x 1
• Cable, flat, 2P, L150 (P/N: 8276292015) x 1
• Cable assy, flat, 50P, P1.0, L180 (P/N: 8277465018) x 1
• 8 x screws (P 3 x 5 CZn)
Model 9045 Contents
Installing Procedures
Loosen 17 x screws (BBT 3 x 8 BZn) fixing the FD-8 Top Panel section to the Bottom Panel section.
Remove the following cables from the connectors on the MAIN PCB assy.
• 7-pin cable to the J10 (from MIXER A PCB assy)
• 9-pin cable to the J11 (from MIXER A PCB assy)
• 9-pin cable to the J3 (from MIXER B PCB assy)
• 9-pin cable to the J7 (from DISPLAY PCB assy)
1)
2)
