FD-8
21
Not like the FD-4 MAIN PCB assy, the E-IDE 50-pin connector J12 and 2-pin cable between W1 and W5 have
already been mounted and soldered. So, it is not necessary to remove the FD-8 MAIN PCB assy when installing
a 2.5” E-IDE hard disk drive.
Using 4 x screws (P 3 x 5 CZn), fix the HD Bracket to a 2.5" E-IDE hard disk drive.
Using 4 x screws (P 3 x 5 CZn), fix the 2.5" E-IDE hard disk drive/HD bracket to the Bottom Panel section.
(During the above procedures 6) and 7), adjust the tightening position of screws to the HDD and to the bottom panel
so that screws are not bothered from each other.)
3)
4)
NOTE:
