21
PURE VIEW: Al
13
HOME FULL GLASS PANEL INSTALLATION
Step 2.
Round ATR Line & End
1. Measure the distance from the inside edge of the 2 posts.
2. Cut the ATR to measured length.
3. The ATR cannot block the inside edge of the post.
As shown in Fig. 3.
4. When test fitting the ATR, place on top of the spacers. Do
not press the ATR down over the spacers. Removing the
ATR from the spacers can damage the ATR and spacers.
As shown in Fig. 2.
5. Remove the backing of all of the double-sided tape on the
ATR spacers.
6. A Rubber Mallet might need to be used to install. If using a
rubber mallet, use a cloth to protect the ATR from damage.
Step 3:
Round ATR Corner
1. When installing ATR on corners with a 2” [51mm] post, the ATR
must be 5/16” [8mm] away from the post. As shown in Fig. 1.
2. If installing a corner with a 3” [76mm] proud post, install
the ATR at full length from the inside edge of the post to the
inside edge of the post.
Fig. 1
Fig. 2
ATR Cannot Go
Past This Line
Fig. 3
ATR Should Not Go Past This
Point When Test Fitting
